GHSA-FWVG-QQFX-4M7G
Vulnerability from github – Published: 2026-11-13 03:32 – Updated: 2026-11-13 03:32MCUboot's serial-recovery image-upload handler bs_upload() in boot/boot_serial/src/boot_serial.c declares const struct flash_area *fap = NULL and assigns it only via flash_area_open() part-way through the function. Two early validation failures (goto out_invalid_data) — a CBOR map that fails to decode, or an upload packet missing the off/data members — branch past the open while fap is still NULL, then fall into the shared epilogue. In MCUBOOT_ENC_IMAGES builds that epilogue unconditionally calls boot_handle_enc_fw(fap), which reaches boot_image_load_header() and flash_area_read() and dereferences the NULL flash_area.
The defect is reachable pre-authentication: the trigger is the very first serial-recovery upload command carrying a malformed payload. The guarding conditions are default-true on a fresh recovery session — img_num, curr_off and img_size are zero-initialized statics, so curr_off == img_size and the primary-slot test both hold. It requires a non-default build: encrypted images (MCUBOOT_ENC_IMAGES / Zephyr CONFIG_BOOT_ENCRYPT_IMAGE) together with an active serial-recovery transport, on the Zephyr or Mynewt port (the two that build both boot/boot_serial/src/boot_serial.c and boot_serial_encryption.c with MCUBOOT_ENC_IMAGES).
The impact is a transient denial of service of the bootloader during recovery. fap is a hard NULL rather than an attacker-controlled value, so there is no memory-corruption or information-leak primitive and image authentication is unaffected. Whether the dereference faults is platform-dependent — on targets where address 0x0 is mapped readable flash the read merely returns an error and execution continues, while targets that trap NULL (MPU / null-pointer-exception detection) take a hard fault. Because serial recovery is unauthenticated by design and already permits the console attacker to write the secondary slot, the added capability is only a low-value transient crash.
The related unconditional flash_area_close(fap) call in the same epilogue is a safe no-op on the ports that reach it, so it does not contribute to the dereference.
The affected ports are the Zephyr port — boot/zephyr/CMakeLists.txt compiles boot_serial.c under CONFIG_MCUBOOT_SERIAL and boot_serial_encryption.c under CONFIG_BOOT_ENCRYPT_IMAGE — and the Mynewt port, whose mcuboot_config.h defines MCUBOOT_SERIAL unconditionally and MCUBOOT_ENC_IMAGES under any BOOTUTIL_ENCRYPT_ syscfg, with boot/boot_serial/pkg.yml declaring no explicit source list so the whole directory is built. The Espressif port is not affected**: it compiles boot_serial.c but not boot_serial_encryption.c, and defines no MCUBOOT_ENC_IMAGES, so the #ifdef MCUBOOT_ENC_IMAGES block containing the call is preprocessed away. The NuttX, Cypress and Mbed ports do not build boot_serial.c at all.
{
"affected": [],
"aliases": [
"CVE-2026-16659"
],
"database_specific": {
"cwe_ids": [
"CWE-476"
],
"github_reviewed": false,
"github_reviewed_at": null,
"nvd_published_at": "2026-11-13T02:18:56Z",
"severity": "MODERATE"
},
"details": "MCUboot\u0027s serial-recovery image-upload handler bs_upload() in boot/boot_serial/src/boot_serial.c declares const struct flash_area *fap = NULL and assigns it only via flash_area_open() part-way through the function. Two early validation failures (goto out_invalid_data) \u2014 a CBOR map that fails to decode, or an upload packet missing the off/data members \u2014 branch past the open while fap is still NULL, then fall into the shared epilogue. In MCUBOOT_ENC_IMAGES builds that epilogue unconditionally calls boot_handle_enc_fw(fap), which reaches boot_image_load_header() and flash_area_read() and dereferences the NULL flash_area.\n\nThe defect is reachable pre-authentication: the trigger is the very first serial-recovery upload command carrying a malformed payload. The guarding conditions are default-true on a fresh recovery session \u2014 img_num, curr_off and img_size are zero-initialized statics, so curr_off == img_size and the primary-slot test both hold. It requires a non-default build: encrypted images (MCUBOOT_ENC_IMAGES / Zephyr CONFIG_BOOT_ENCRYPT_IMAGE) together with an active serial-recovery transport, on the Zephyr or Mynewt port (the two that build both boot/boot_serial/src/boot_serial.c and boot_serial_encryption.c with MCUBOOT_ENC_IMAGES).\n\nThe impact is a transient denial of service of the bootloader during recovery. fap is a hard NULL rather than an attacker-controlled value, so there is no memory-corruption or information-leak primitive and image authentication is unaffected. Whether the dereference faults is platform-dependent \u2014 on targets where address 0x0 is mapped readable flash the read merely returns an error and execution continues, while targets that trap NULL (MPU / null-pointer-exception detection) take a hard fault. Because serial recovery is unauthenticated by design and already permits the console attacker to write the secondary slot, the added capability is only a low-value transient crash.\n\nThe related unconditional flash_area_close(fap) call in the same epilogue is a safe no-op on the ports that reach it, so it does not contribute to the dereference.\n\nThe affected ports are the Zephyr port \u2014 boot/zephyr/CMakeLists.txt compiles boot_serial.c under CONFIG_MCUBOOT_SERIAL and boot_serial_encryption.c under CONFIG_BOOT_ENCRYPT_IMAGE \u2014 and the Mynewt port, whose mcuboot_config.h defines MCUBOOT_SERIAL unconditionally and MCUBOOT_ENC_IMAGES under any BOOTUTIL_ENCRYPT_ syscfg, with boot/boot_serial/pkg.yml declaring no explicit source list so the whole directory is built. The Espressif port is not affected**: it compiles boot_serial.c but not boot_serial_encryption.c, and defines no MCUBOOT_ENC_IMAGES, so the #ifdef MCUBOOT_ENC_IMAGES block containing the call is preprocessed away. The NuttX, Cypress and Mbed ports do not build boot_serial.c at all.",
"id": "GHSA-fwvg-qqfx-4m7g",
"modified": "2026-11-13T03:32:01Z",
"published": "2026-11-13T03:32:01Z",
"references": [
{
"type": "WEB",
"url": "https://github.com/mcu-tools/mcuboot/security/advisories/GHSA-777r-3chm-p78c"
},
{
"type": "ADVISORY",
"url": "https://nvd.nist.gov/vuln/detail/CVE-2026-16659"
},
{
"type": "WEB",
"url": "https://github.com/mcu-tools/mcuboot/commit/400f9a7242641655948b08acac19932f56d9881f"
}
],
"schema_version": "1.4.0",
"severity": [
{
"score": "CVSS:3.1/AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:L",
"type": "CVSS_V3"
}
]
}
Sightings
| Author | Source | Type | Date | Other |
|---|
Nomenclature
- Seen: The vulnerability was mentioned, discussed, or observed by the user.
- Confirmed: The vulnerability has been validated from an analyst's perspective.
- Published Proof of Concept: A public proof of concept is available for this vulnerability.
- Exploited: The vulnerability was observed as exploited by the user who reported the sighting.
- Patched: The vulnerability was observed as successfully patched by the user who reported the sighting.
- Not exploited: The vulnerability was not observed as exploited by the user who reported the sighting.
- Not confirmed: The user expressed doubt about the validity of the vulnerability.
- Not patched: The vulnerability was not observed as successfully patched by the user who reported the sighting.
The approach is described in our paper Mapping CVEs to MITRE ATT&CK Techniques: A Curated Gold-Set Classifier and the Limits of LLM-Assisted Label Expansion.
Browse all ATT&CK techniques and the vulnerabilities related to each.
Related by attack behaviour
Vulnerabilities whose description is nearest to this one in the vector space of the CIRCL/vulnerability-attack-technique-biencoder model. This is a similarity search over the bi-encoder space (plain cosine), not a classification, and it has no measured accuracy.