CVE-2026-43363 — x86/apic: Disable x2apic on resume if the kernel expects so

Affected: Linux

In the Linux kernel, the following vulnerability has been resolved:

x86/apic: Disable x2apic on resume if the kernel expects so

When resuming from s2ram, firmware may re-enable x2apic mode, which may have been disabled by the kernel during boot either because it doesn't support IRQ remapping or for other reasons. This causes the kernel to continue using the xapic interface, while the hardware is in x2apic mode, which causes hangs. This happens on defconfig + bare metal + s2ram.

Fix this in lapic_resume() by disabling x2apic if the kernel expects it to be disabled, i.e. when x2apic_mode = 0.

The ACPI v6.6 spec, Section 16.3 [1] says firmware restores either the pre-sleep configuration or initial boot configuration for each CPU, including MSR state:

When executing from the power-on reset vector as a result of waking from an S2 or S3 sleep state, the platform firmware performs only the hardware initialization required to restore the system to either the state the platform was in prior to the initial operating system boot, or to the pre-sleep configuration state. In multiprocessor systems, non-boot processors should be placed in the same state as prior to the initial operating system boot.

(further ahead)

If this is an S2 or S3 wake, then the platform runtime firmware restores minimum context of the system before jumping to the waking vector. This includes:

CPU configuration. Platform runtime firmware restores the pre-sleep configuration or initia…

USN-8567-1 — linux, linux-gcp, linux-gcp-6.8, linux-gke, linux-gkeop, linux-realtime, linux-realtime-6.8 vulnerabilities

Affected: Ubuntu:22.04:LTS: linux-gcp-6.8, Ubuntu:Pro:Realtime:22.04:LTS: linux-realtime-6.8, Ubuntu:24.04:LTS: linux, Ubuntu:24.04:LTS: linux-gcp, Ubuntu:24.04:LTS: linux-gke, Ubuntu:24.04:LTS: linux-gkeop, Ubuntu:Pro:Realtime:24.04:LTS: linux-realtime

It was discovered that some AMD processors did not properly clear data in the floating point divider unit during speculative execution. A local attacker could use this to expose sensitive information. (CVE-2025-54505)

It was discovered that some AMD Zen 2 processors did not properly isolate shared resources in the operation cache. A local attacker could possibly use this issue to corrupt instructions executed at a higher privilege level, resulting in privilege escalation. (CVE-2025-54518)

It was discovered that some AMD Zen 5 processors supporting RDSEED instruction did not properly handle entropy, potentially resulting in the consumption of insufficiently random values. A local attacker could possibly use this issue to influence the values returned by the RDSEED instruction causing loss of confidentiality and integrity. (CVE-2025-62626)

Several security issues were discovered in the Linux kernel. An attacker could possibly use these to compromise the system. This update corrects flaws in the following subsystems: - ARM64 architecture; - RISC-V architecture; - S390 architecture; - x86 architecture; - Block layer subsystem; - Cryptographic API; - Compute Acceleration Framework; - ACPI drivers; - Serial ATA and Parallel ATA drivers; - Drivers core; - Power management core; - DRBD Distributed Replicated Block Device drivers; - Rados block device (RBD) driver; - Compressed RAM block device driver; - Bluetooth drivers; - Bus devices; - Charact…

Most recent entries from all

CVE-2026-43363 — x86/apic: Disable x2apic on resume if the kernel expects so

USN-8567-1 — linux, linux-gcp, linux-gcp-6.8, linux-gke, linux-gkeop, linux-realtime, linux-realtime-6.8 vulnerabilities