Most recent entries from all

BELL-CVE-2026-98254

Affected: Alpaquita:23: linux-lts, Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts

EUVD-2026-383366

fkie_cve-2026-98254

In the Linux kernel, the following vulnerability has been resolved:

swiotlb: use the adjusted address for the highmem page lookup

swiotlb_bounce() reads the page frame number from the slot's recorded orig_addr, then advances orig_addr by tlb_offset to reach the address the caller asked about. The highmem branch mixes the two: the offset within the page comes from the adjusted address, the page from the value before it.

Once the adjustment crosses a page boundary the pair no longer describes one location, and the whole copy lands one page below the intended one for a positive tlb_offset, one above for a negative one. DMA_FROM_DEVICE writes the device data over the wrong page and leaves the intended one stale, DMA_TO_DEVICE feeds the device from a page the mapping may not cover. Partial syncs through dma_sync_single_range_for_*() are what make tlb_offset non-zero.

The branch test is picked the same way, so a slot recorded in lowmem can be adjusted into highmem and the lowmem path then hands a highmem address to phys_to_virt().

Take both from orig_addr once it is final and keep pfn in the branch that uses it. PhysHighMem() asks the question straight from the address, as dma-debug already does.

GHSA-hrh5-h3h2-8q3j

In the Linux kernel, the following vulnerability has been resolved:

swiotlb: use the adjusted address for the highmem page lookup

The branch test is picked the same way, so a slot recorded in lowmem can be adjusted into highmem and the lowmem path then hands a highmem address to phys_to_virt().

Take both from orig_addr once it is final and keep pfn in the branch that uses it. PhysHighMem() asks the question straight from the address, as dma-debug already does.

msrc_CVE-2026-98254 — swiotlb: use the adjusted address for the highmem page lookup

msrc_CVE-2026-98254

UBUNTU-CVE-2026-98254

Affected: Ubuntu:16.04:LTS: linux-hwe-edge, Ubuntu:18.04:LTS: linux-aws-5.0, Ubuntu:18.04:LTS: linux-aws-5.3, Ubuntu:18.04:LTS: linux-azure, Ubuntu:18.04:LTS: linux-azure-5.3, Ubuntu:18.04:LTS: linux-azure-edge, Ubuntu:18.04:LTS: linux-gcp, Ubuntu:18.04:LTS: linux-gcp-5.3, Ubuntu:Pro:18.04:LTS: linux-gcp-5.4, Ubuntu:18.04:LTS: linux-gke-4.15 and 196 more

In the Linux kernel, the following vulnerability has been resolved: swiotlb: use the adjusted address for the highmem page lookup swiotlb_bounce() reads the page frame number from the slot's recorded orig_addr, then advances orig_addr by tlb_offset to reach the address the caller asked about. The highmem branch mixes the two: the offset within the page comes from the adjusted address, the page from the value before it. Once the adjustment crosses a page boundary the pair no longer describes one location, and the whole copy lands one page below the intended one for a positive tlb_offset, one above for a negative one. DMA_FROM_DEVICE writes the device data over the wrong page and leaves the intended one stale, DMA_TO_DEVICE feeds the device from a page the mapping may not cover. Partial syncs through dma_sync_single_range_for_*() are what make tlb_offset non-zero. The branch test is picked the same way, so a slot recorded in lowmem can be adjusted into highmem and the lowmem path then hands a highmem address to phys_to_virt(). Take both from orig_addr once it is final and keep pfn in the branch that uses it. PhysHighMem() asks the question straight from the address, as dma-debug already does.