https://cve.radiocsirt.org Contains only the most 10 recent entries. http://www.rssboard.org/rss-specification python-feedgen en Sat, 03 Oct 2026 18:26:49 +0000 https://cve.radiocsirt.org/vuln/bell-cve-2026-64125 <p><strong>Affected:</strong> Alpaquita:23: linux-lts, Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts</p> <p><strong>Affected:</strong> Alpaquita:23: linux-lts, Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts</p> https://cve.radiocsirt.org/vuln/bell-cve-2026-64125 https://cve.radiocsirt.org/vuln/certfr-2026-avi-0926 certfr-2026-avi-0926 https://cve.radiocsirt.org/vuln/certfr-2026-avi-0926 https://cve.radiocsirt.org/vuln/euvd-2026-348419 EUVD-2026-348419 https://cve.radiocsirt.org/vuln/euvd-2026-348419 https://cve.radiocsirt.org/vuln/fkie_cve-2026-64125 <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> https://cve.radiocsirt.org/vuln/fkie_cve-2026-64125 https://cve.radiocsirt.org/vuln/ghsa-89rr-cfw2-c9px <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> https://cve.radiocsirt.org/vuln/ghsa-89rr-cfw2-c9px https://cve.radiocsirt.org/vuln/opensuse-su-2026:21910-1 <p>Security update for the Linux Kernel</p> <p>Security update for the Linux Kernel</p> https://cve.radiocsirt.org/vuln/opensuse-su-2026:21910-1 https://cve.radiocsirt.org/vuln/suse-su-2026:23477-1 <p>Security update for the Linux Kernel</p> <p>Security update for the Linux Kernel</p> https://cve.radiocsirt.org/vuln/suse-su-2026:23477-1 https://cve.radiocsirt.org/vuln/ubuntu-cve-2026-64125 <p><strong>Affected:</strong> Ubuntu:Pro:14.04:LTS: linux-aws, Ubuntu:Pro:14.04:LTS: linux-azure, Ubuntu:Pro:14.04:LTS: linux-lts-xenial, Ubuntu:Pro:16.04:LTS: linux, Ubuntu:Pro:16.04:LTS: linux-aws, Ubuntu:Pro:16.04:LTS: linux-aws-hwe, Ubuntu:Pro:16.04:LTS: linux-azure, Ubuntu:Pro:16.04:LTS: linux-gcp, Ubuntu:Pro:16.04:LTS: linux-hwe, Ubuntu:16.04:LTS: linux-hwe-edge and 244 more</p> <p>In the Linux kernel, the following vulnerability has been resolved: net: bcmgenet: keep RBUF EEE/PM disabled Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit. Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented. This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes. Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> <p><strong>Affected:</strong> Ubuntu:Pro:14.04:LTS: linux-aws, Ubuntu:Pro:14.04:LTS: linux-azure, Ubuntu:Pro:14.04:LTS: linux-lts-xenial, Ubuntu:Pro:16.04:LTS: linux, Ubuntu:Pro:16.04:LTS: linux-aws, Ubuntu:Pro:16.04:LTS: linux-aws-hwe, Ubuntu:Pro:16.04:LTS: linux-azure, Ubuntu:Pro:16.04:LTS: linux-gcp, Ubuntu:Pro:16.04:LTS: linux-hwe, Ubuntu:16.04:LTS: linux-hwe-edge and 244 more</p> <p>In the Linux kernel, the following vulnerability has been resolved: net: bcmgenet: keep RBUF EEE/PM disabled Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit. Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented. This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes. Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> https://cve.radiocsirt.org/vuln/ubuntu-cve-2026-64125 https://cve.radiocsirt.org/vuln/wid-sec-w-2026-2403 <p>Ein Angreifer kann mehrere Schwachstellen im Linux Kernel ausnutzen, um einen nicht näher spezifizierten Angriff durchzuführen, möglicherweise Sicherheitsmaßnahmen zu umgehen, einen Denial-of-Service-Zustand herbeizuführen oder vertrauliche Informationen offenzulegen.</p> <p>Ein Angreifer kann mehrere Schwachstellen im Linux Kernel ausnutzen, um einen nicht näher spezifizierten Angriff durchzuführen, möglicherweise Sicherheitsmaßnahmen zu umgehen, einen Denial-of-Service-Zustand herbeizuführen oder vertrauliche Informationen offenzulegen.</p> https://cve.radiocsirt.org/vuln/wid-sec-w-2026-2403