https://cve.radiocsirt.org Contains only the most 10 recent entries. http://www.rssboard.org/rss-specification python-feedgen en Sun, 04 Oct 2026 04:14:07 +0000 https://cve.radiocsirt.org/vuln/bdu:2025-05978 bdu:2025-05978 https://cve.radiocsirt.org/vuln/bdu:2025-05978 https://cve.radiocsirt.org/vuln/bell-cve-2024-46842 <p><strong>Affected:</strong> Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts</p> <p><strong>Affected:</strong> Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts</p> https://cve.radiocsirt.org/vuln/bell-cve-2024-46842 https://cve.radiocsirt.org/vuln/certfr-2024-avi-0999 certfr-2024-avi-0999 https://cve.radiocsirt.org/vuln/certfr-2024-avi-0999 https://cve.radiocsirt.org/vuln/euvd-2026-346141 EUVD-2026-346141 https://cve.radiocsirt.org/vuln/euvd-2026-346141 https://cve.radiocsirt.org/vuln/fkie_cve-2024-46842 <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info</p> <p>The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine.</p> <p>Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine.</p> <p>Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info</p> <p>The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine.</p> <p>Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine.</p> <p>Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> https://cve.radiocsirt.org/vuln/fkie_cve-2024-46842 https://cve.radiocsirt.org/vuln/ghsa-97x4-gv8v-28vq <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info</p> <p>The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine.</p> <p>Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine.</p> <p>Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info</p> <p>The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine.</p> <p>Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine.</p> <p>Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> https://cve.radiocsirt.org/vuln/ghsa-97x4-gv8v-28vq https://cve.radiocsirt.org/vuln/msrc_cve-2024-46842 msrc_CVE-2024-46842 https://cve.radiocsirt.org/vuln/msrc_cve-2024-46842 https://cve.radiocsirt.org/vuln/oesa-2024-2219 <p><strong>Affected:</strong> openEuler:24.03-LTS: kernel</p> <p>The Linux Kernel, the operating system core itself. Security Fix(es): In the Linux kernel, the following vulnerability has been resolved: bpf: Take return from set_memory_rox() into account with bpf_jit_binary_lock_ro() set_memory_rox() can fail, leaving memory unprotected. Check return and bail out when bpf_jit_binary_lock_ro() returns an error.(CVE-2024-42067) In the Linux kernel, the following vulnerability has been resolved: sysctl: always initialize i_uid/i_gid Always initialize i_uid/i_gid inside the sysfs core so set_ownership() can safely skip setting them. Commit 5ec27ec735ba (&amp;quot;fs/proc/proc_sysctl.c: fix the default values of i_uid/i_gid on /proc/sys inodes.&amp;quot;) added defaults for i_uid/i_gid when set_ownership() was not implemented. It also missed adjusting net_ctl_set_ownership() to use the same default values in case the computation of a better value failed.(CVE-2024-42312) In the Linux kernel, the following vulnerability has been resolved: parisc: fix a possible DMA corruption ARCH_DMA_MINALIGN was defined as 16 - this is too small - it may be possible that two unrelated 16-byte allocations share a cache line. If one of these allocations is written using DMA and the other is written using cached write, the value that was written with DMA may be corrupted. This commit changes ARCH_DMA_MINALIGN to be 128 on PA20 and 32 on PA1.1 - that&amp;apos;s the largest possible cache line size. As different parisc microarchitectur…</p> <p><strong>Affected:</strong> openEuler:24.03-LTS: kernel</p> <p>The Linux Kernel, the operating system core itself. Security Fix(es): In the Linux kernel, the following vulnerability has been resolved: bpf: Take return from set_memory_rox() into account with bpf_jit_binary_lock_ro() set_memory_rox() can fail, leaving memory unprotected. Check return and bail out when bpf_jit_binary_lock_ro() returns an error.(CVE-2024-42067) In the Linux kernel, the following vulnerability has been resolved: sysctl: always initialize i_uid/i_gid Always initialize i_uid/i_gid inside the sysfs core so set_ownership() can safely skip setting them. Commit 5ec27ec735ba (&amp;quot;fs/proc/proc_sysctl.c: fix the default values of i_uid/i_gid on /proc/sys inodes.&amp;quot;) added defaults for i_uid/i_gid when set_ownership() was not implemented. It also missed adjusting net_ctl_set_ownership() to use the same default values in case the computation of a better value failed.(CVE-2024-42312) In the Linux kernel, the following vulnerability has been resolved: parisc: fix a possible DMA corruption ARCH_DMA_MINALIGN was defined as 16 - this is too small - it may be possible that two unrelated 16-byte allocations share a cache line. If one of these allocations is written using DMA and the other is written using cached write, the value that was written with DMA may be corrupted. This commit changes ARCH_DMA_MINALIGN to be 128 on PA20 and 32 on PA1.1 - that&amp;apos;s the largest possible cache line size. As different parisc microarchitectur…</p> https://cve.radiocsirt.org/vuln/oesa-2024-2219 https://cve.radiocsirt.org/vuln/suse-su-2024:3984-1 <p>Security update for the Linux Kernel</p> <p>Security update for the Linux Kernel</p> https://cve.radiocsirt.org/vuln/suse-su-2024:3984-1 https://cve.radiocsirt.org/vuln/ubuntu-cve-2024-46842 <p><strong>Affected:</strong> Ubuntu:Pro:14.04:LTS: linux, Ubuntu:Pro:14.04:LTS: linux-aws, Ubuntu:Pro:14.04:LTS: linux-azure, Ubuntu:Pro:14.04:LTS: linux-lts-xenial, Ubuntu:Pro:16.04:LTS: linux, Ubuntu:Pro:16.04:LTS: linux-aws, Ubuntu:Pro:16.04:LTS: linux-aws-hwe, Ubuntu:Pro:16.04:LTS: linux-azure, Ubuntu:Pro:16.04:LTS: linux-gcp, Ubuntu:Pro:16.04:LTS: linux-hwe and 188 more</p> <p>In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine. Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine. Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> <p><strong>Affected:</strong> Ubuntu:Pro:14.04:LTS: linux, Ubuntu:Pro:14.04:LTS: linux-aws, Ubuntu:Pro:14.04:LTS: linux-azure, Ubuntu:Pro:14.04:LTS: linux-lts-xenial, Ubuntu:Pro:16.04:LTS: linux, Ubuntu:Pro:16.04:LTS: linux-aws, Ubuntu:Pro:16.04:LTS: linux-aws-hwe, Ubuntu:Pro:16.04:LTS: linux-azure, Ubuntu:Pro:16.04:LTS: linux-gcp, Ubuntu:Pro:16.04:LTS: linux-hwe and 188 more</p> <p>In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine. Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine. Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.</p> https://cve.radiocsirt.org/vuln/ubuntu-cve-2024-46842 https://cve.radiocsirt.org/vuln/wid-sec-w-2024-3050 <p>Ein lokaler Angreifer kann mehrere Schwachstellen in Linux Kernel ausnutzen, um einen Denial of Service Angriff durchzuführen und andere nicht spezifizierte Auswirkungen zu verursachen.</p> <p>Ein lokaler Angreifer kann mehrere Schwachstellen in Linux Kernel ausnutzen, um einen Denial of Service Angriff durchzuführen und andere nicht spezifizierte Auswirkungen zu verursachen.</p> https://cve.radiocsirt.org/vuln/wid-sec-w-2024-3050