https://cve.radiocsirt.org/rss/recent/all/10 Most recent entries from all 2026-10-14T23:06:47.950554+00:00 Vulnerability-Lookup csirt@opendfir.org python-feedgen Contains only the most 10 recent entries. https://cve.radiocsirt.org/vuln/cve-2025-68236 CVE-2025-68236 — scsi: ufs: ufs-qcom: Fix UFS OCP issue during UFS power down (PC=3) 2026-10-14T23:06:47.986974+00:00

Affected: Linux

In the Linux kernel, the following vulnerability has been resolved:

scsi: ufs: ufs-qcom: Fix UFS OCP issue during UFS power down (PC=3)

According to UFS specifications, the power-off sequence for a UFS device includes:

- Sending an SSU command with Power_Condition=3 and await a response.

- Asserting RST_N low.

- Turning off REF_CLK.

- Turning off VCC.

- Turning off VCCQ/VCCQ2.

As part of ufs shutdown, after the SSU command completion, asserting hardware reset (HWRST) triggers the device firmware to wake up and execute its reset routine. This routine initializes hardware blocks and takes a few milliseconds to complete. During this time, the ICCQ draws a large current.

This large ICCQ current may cause issues for the regulator which is supplying power to UFS, because the turn off request from UFS driver to the regulator framework will be immediately followed by low power mode(LPM) request by regulator framework. This is done by framework because UFS which is the only client is requesting for disable. So if the rail is still in the process of shutting down while ICCQ exceeds LPM current thresholds, and LPM mode is activated in hardware during this state, it may trigger an overcurrent protection (OCP) fault in the regulator.

To prevent this, a 10ms delay is added after asserting HWRST. This allows the reset operation to complete while power rails remain active and in high-power mode.

Currently there is no way for Host to query whether the reset is completed or no…

 https://cve.radiocsirt.org/vuln/usn-8094-1 USN-8094-1 — linux, linux-aws, linux-aws-6.17, linux-gcp, linux-hwe-6.17, linux-oracle, linux-oracle-6.17 vulnerabilities 2026-10-14T23:06:47.987063+00:00

Affected: Ubuntu:24.04:LTS: linux-aws-6.17, Ubuntu:24.04:LTS: linux-hwe-6.17, Ubuntu:24.04:LTS: linux-oracle-6.17, Ubuntu:25.10: linux, Ubuntu:25.10: linux-aws, Ubuntu:25.10: linux-gcp, Ubuntu:25.10: linux-oracle

Qualys discovered that several vulnerabilities existed in the AppArmor Linux kernel Security Module (LSM). An unprivileged local attacker could use these issues to load, replace, and remove arbitrary AppArmor profiles causing denial of service, exposure of sensitive information (kernel memory), local privilege escalation, or possibly escape a container. (LP: #2143853)

It was discovered that some AMD Zen 5 processors supporting RDSEED instruction did not properly handle entropy, potentially resulting in the consumption of insufficiently random values. A local attacker could possibly use this issue to influence the values returned by the RDSEED instruction causing loss of confidentiality and integrity. (CVE-2025-62626)

Several security issues were discovered in the Linux kernel. An attacker could possibly use these to compromise the system. This update corrects flaws in the following subsystems: - ARM64 architecture; - S390 architecture; - x86 architecture; - Block layer subsystem; - Cryptographic API; - Compute Acceleration Framework; - ATM drivers; - Network block device driver; - Bluetooth drivers; - Data acquisition framework and drivers; - Hardware crypto device drivers; - Device frequency scaling framework; - Intel Stratix 10 firmware drivers; - GPIO subsystem; - GPU drivers; - Microsoft Hyper-V drivers; - CoreSight HW tracing drivers; - IIO subsystem; - InfiniBand drivers; - Input Device core drivers; - Input Device (Tablet) d…