Affected: AlmaLinux:8: bpftool, AlmaLinux:8: kernel, AlmaLinux:8: kernel-abi-stablelists, AlmaLinux:8: kernel-core, AlmaLinux:8: kernel-cross-headers, AlmaLinux:8: kernel-debug, AlmaLinux:8: kernel-debug-core, AlmaLinux:8: kernel-debug-devel, AlmaLinux:8: kernel-debug-modules, AlmaLinux:8: kernel-debug-modules-extra and 15 more

The kernel packages contain the Linux kernel, the core of any Linux operating system.

Security Fix(es):

* kernel: drm/amdgpu: Fix fence put before wait in amdgpu_amdkfd_submit_ib (CVE-2026-31566) * kernel: netfilter: nf_queue: hold bridge skb->dev while queued (CVE-2026-52912) * kernel: Linux kernel: PPPoE memory corruption via stale pointer (CVE-2026-68121) * kernel: Linux kernel IPVS: Denial of Service due to stale memory references (CVE-2026-80714) * kernel: nvme-tcp: reject a read that transferred too few bytes (CVE-2026-89480)

For more details about the security issue(s), including the impact, a CVSS score, acknowledgments, and other related information, refer to the CVE page(s) listed in the References section.

Affected: Alpaquita:23: linux-lts, Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts

In the Linux kernel, the following vulnerability has been resolved:

nvme-tcp: reject a read that transferred too few bytes

nvme_tcp_recv_data() completes a request once the current C2HData PDU has been consumed. Nothing compares the total bytes received against the length the command asked for: struct nvme_tcp_request has no receive-side counter, queue->data_remaining is per queue, and blk_mq_end_request() completes for blk_rq_bytes(rq) unconditionally with no residual concept anywhere above.

A controller can therefore answer a 4096-byte read with 512 bytes and have it reported as a complete read; user space then gets 4096 bytes of which 3584 are whatever was already in the page. I reproduced that with a test target.

Count the bytes received and refuse to complete a successful read whose count does not match, at the two NVME_TCP_F_DATA_SUCCESS paths and in nvme_tcp_process_nvme_cqe(). The success test shifts req->status right by one, because the driver keeps the wire value there and shifts it on completion, so the check must see what the completion path will see. Only REQ_OP_READ is checked, because there the length comes from the sectors the request covers; a passthrough command is built by its submitter, which picks both command and buffer, so the kernel has nothing to compare against.

In the Linux kernel, the following vulnerability has been resolved:

nvme-tcp: reject a read that transferred too few bytes

nvme_tcp_recv_data() completes a request once the current C2HData PDU has been consumed. Nothing compares the total bytes received against the length the command asked for: struct nvme_tcp_request has no receive-side counter, queue->data_remaining is per queue, and blk_mq_end_request() completes for blk_rq_bytes(rq) unconditionally with no residual concept anywhere above.

A controller can therefore answer a 4096-byte read with 512 bytes and have it reported as a complete read; user space then gets 4096 bytes of which 3584 are whatever was already in the page. I reproduced that with a test target.

Count the bytes received and refuse to complete a successful read whose count does not match, at the two NVME_TCP_F_DATA_SUCCESS paths and in nvme_tcp_process_nvme_cqe(). The success test shifts req->status right by one, because the driver keeps the wire value there and shifts it on completion, so the check must see what the completion path will see. Only REQ_OP_READ is checked, because there the length comes from the sectors the request covers; a passthrough command is built by its submitter, which picks both command and buffer, so the kernel has nothing to compare against.

kernel-devel-7.2.7-1.1 on GA media

kernel: drm/amdgpu: Fix fence put before wait in amdgpu_amdkfd_submit_ib kernel: netfilter: nf_queue: hold bridge skb->dev while queued kernel: pppoe: reload header pointer after dev_hard_header() kernel: ipvs: do not propagate one-packet flag to synced conns kernel: nvme-tcp: reject a read that transferred too few bytes

Affected: Rocky Linux:8: kernel

The kernel packages contain the Linux kernel, the core of any Linux operating system.

Security Fix(es):

* kernel: drm/amdgpu: Fix fence put before wait in amdgpu_amdkfd_submit_ib (CVE-2026-31566)

* kernel: netfilter: nf_queue: hold bridge skb->dev while queued (CVE-2026-52912)

* kernel: Linux kernel: PPPoE memory corruption via stale pointer (CVE-2026-68121)

* kernel: Linux kernel IPVS: Denial of Service due to stale memory references (CVE-2026-80714)

* kernel: nvme-tcp: reject a read that transferred too few bytes (CVE-2026-89480)

For more details about the security issue(s), including the impact, a CVSS score, acknowledgments, and other related information, refer to the CVE page(s) listed in the References section.

Affected: Ubuntu:16.04:LTS: linux-hwe-edge, Ubuntu:18.04:LTS: linux-aws-5.0, Ubuntu:18.04:LTS: linux-aws-5.3, Ubuntu:Pro:18.04:LTS: linux-aws-5.4, Ubuntu:18.04:LTS: linux-azure, Ubuntu:18.04:LTS: linux-azure-5.3, Ubuntu:Pro:18.04:LTS: linux-azure-5.4, Ubuntu:18.04:LTS: linux-azure-edge, Ubuntu:18.04:LTS: linux-gcp, Ubuntu:18.04:LTS: linux-gcp-5.3 and 219 more

In the Linux kernel, the following vulnerability has been resolved: nvme-tcp: reject a read that transferred too few bytes nvme_tcp_recv_data() completes a request once the current C2HData PDU has been consumed. Nothing compares the total bytes received against the length the command asked for: struct nvme_tcp_request has no receive-side counter, queue->data_remaining is per queue, and blk_mq_end_request() completes for blk_rq_bytes(rq) unconditionally with no residual concept anywhere above. A controller can therefore answer a 4096-byte read with 512 bytes and have it reported as a complete read; user space then gets 4096 bytes of which 3584 are whatever was already in the page. I reproduced that with a test target. Count the bytes received and refuse to complete a successful read whose count does not match, at the two NVME_TCP_F_DATA_SUCCESS paths and in nvme_tcp_process_nvme_cqe(). The success test shifts req->status right by one, because the driver keeps the wire value there and shifts it on completion, so the check must see what the completion path will see. Only REQ_OP_READ is checked, because there the length comes from the sectors the request covers; a passthrough command is built by its submitter, which picks both command and buffer, so the kernel has nothing to compare against.

Ein Angreifer kann mehrere Schwachstellen im Linux Kernel ausnutzen, um Sicherheitsmaßnahmen zu umgehen, Daten oder den Systemzustand zu manipulieren, Denial-of-Service-Zustände herbeizuführen oder andere, nicht näher spezifizierte Angriffe durchzuführen.